Making A Simple Loop
Step 1: Using round nose pliers, grip the wire of the headpin (T Pin) just above the last bead added. Bend the wire to a 90° angle. Using wire cutters, trim the wire to 1 cm
Step 2: Grip the end of the cut wire with the tip of the round nose pliers; have very little wire peaking through the barrels of the pliers
Step 3: Rotate your wrist away from your body, while pushing, with your thumb of your other hand, on the wire below the forming loop; turn the wire into a loop.
Step 4: If necessary, adjust the loop so it is centered.
You may also want to see: Beading Video - Forming a Loop
