Top-Drilled Bicone Bracelet
6mm 6301: Crsytal AB x 6 pcs, Rose x 6 pcs, Siam x 6 pcs
6mm 5301: Amethyst x 5 pcs
Silver Beads, Crimp Beads, Spacer, Toggle Clasp, Soft Wire
|
|
Cut a 25cm of Soft Wire (Tiger Tail). String a Crimp Bead, a Silver Bead and attach to the loop of a Toggle Clasp. |
|
|
Bring approx. 2 cm of the wire back through the Silver Bead and Crimp Bead. |
|
|
Tighten gently and flatten the Crimp Bead using Chain Nose / Flat Nose Pliers. |
|
|
Start you beadwork (refer to first picture on top): 1 Silver Bead, 1 6mm 6301 Crystal AB, 1 6mm 6301 Rose, 1 6mm 6301 Siam, 1 Silver Bead, 1 Spacer, 1 Silver Bead, 1 6mm 5301 Amethyst, 1 Silver Bead and 1 Spacer. Repeat beadwork until the bracelet wraps around your wrist with little lag. |
|
|
To finish, string 1 Silver Bead, 1 Crimp Bead and another Silver Bead and attach to the loop of the other toogle clasp. Bring the remainder of your Soft Wire back through the few beads of your beadwork. Crimp and Crimp Bead and cut off excess wire. |
|
|
Oh my goodness! Not sure if you have noticed that i’m attaching the wrong pair of toggle claps to the bracelet. How am i going to wear this bracelet on her wrist??? This is the most annoying part of Beading if you have to start over again from beginning…  Not sure if you ever had this kind of experiece. |
